The PIC slots on the upper FPC are numbered from 0/0 (zero/zero) through. Part Number: M10IBASE. PIC slot numbering in horizontally aligned systems such as the M7i and M10i is a little less standard. This article describes what can happen when a PIC is improperly inserted into a slot on the M10i device: the neighboring PIC can malfunction. M10IBASE-DC Juniper M10i Base Unit 8 Pic Slot Chassis Cooling Midplane 2 Dc Power Supplies 1 Forwarding Engine 1 Routin (Refurbished). The command output for an M10i router. slot 3 is used for the fixed Ethernet interfaces. . Four PIC slots are located in each Flexible PIC Concentrator (FPC). of Gbps per FPC on m10i routers. M10IBASE-DC Juniper M10i Base Unit 8 Pic Slot Chassis Cooling Midplane 2 Dc Power Supplies 1 Forwarding Engine 1 Routin (Refurbished) ; Was: $ ; Part #. To check PIC status including port information, use the show chassis pic pic-slot # fpc-slot # command. In these systems, the PIC slot numbering goes from right. Available. The M7i and M10i routers are the choice for consolidating multiple services onto a single IP/MPLS Number of PIC Slots. Figure PIC slot numbers for M7i, M10i, and M20 Figure M7i PIC slot numbering In the SRX and MX. 8 open slots. Does it mean that there is Mbps limitation on each PIC inserted in PIC slot on given FPC? Or is it an. 4 open slots.